Rv Awning Motor Maintenance

Inspect pull strap slide pins rv awning motor if its electric awning.

Rv awning motor maintenance.

This will work for both acrylic and vinyl awnings. Repairing the rv awning power switch. Ultraviolet rays from the sun will also take their toll on your awning. Step 3 fix warped rails.

Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket. While you are attaching your awning make sure not to take the end caps out. One way to repair a motorized awning is to simply lubricate the working parts with some machine oil. Protect your rv awning from the damaging effects of uv radiation.

The manual advises using a mixture of cup bleach cup dishwashing liquid added to 5 gallons of water. You re just trying to get the dirt off not deep clean the awning. Here are seven tips for regular rv awning maintenance. You yourself can replace most parts of the awning apart from few things like fabric and awning arms.

You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes. There can be several reasons for that and a repair man should be able to check on that. Don t remove end caps. Always let the awning air dry don t use heaters.

If that does not happen then the motor has gone bad. Locate the supply connection terminal on the motor and connect it with the battery supply wires that you will have. Keep the water temperature less than 100 degrees fahrenheit. Rub down the rails pulley rollers and retracting arm to make sure they are not sticking due to friction rust or dirt.

Tips to maintain your rv awning. I disassembled the control panel and swapped the slide out room switch it uses the same switch with the power awning switch and the fault swapped as well. By doing this the motor should start to operate and extend or retract the awning. Remove the bad motor and replace it with the new one.

Our large 21 foot dometic 9100 rv power awning is made out of vinyl and has held up very well after 4 years of full time rving. I generally clean it every few months by following the procedure outlined in the owner s manual. There is no purpose to take them out unless you want to replace the awning. Electric rv awning operation is simple enough and easy to maintain.

I tried the awning using it and it worked.